| CEA-2006 Compliant |
 |
| Number of Channels |
4 |
Rated Power
continuous power |
150 Watts RMS x 4 @ 4-Ohms
250 Watts RMS x 4 @ 2-Ohms
500 Watts RMS x 2 @ 4-Ohms bridged/mono
STABLE @ 2-Ohms x 2 bridged/mono (reduced thermal time may occur) |
Total Power
total sum of 'rated power' |
1000 Watts |
Dynamic Power
powercube measurement
|
Front Channels
222 Watts x 2 @ 4-Ohms 0° Res
390 Watts x 2 @ 2-Ohms 0° Res
Rear Channels
223 Watts x 2 @ 4-Ohms 0° Res
387 Watts x 2 @ 2-Ohms 0° Res |
| Bridgeable |
Yes |
| Efficiency (average) |
70% @ 4-Ohms
65% @ 2-Ohms |
| Crossover Controls |
Front Channels:
High-Pass (HP): 50Hz-500Hz @ 24dB/octave Butterworth Low-Pass (LP): 50Hz-500Hz @ 24dB/octave Butterworth
Rear Channels:
High-Pass (HP): 50Hz-500Hz @ 24dB/octave Butterworth
Low-Pass (LP): 50Hz-500Hz @ 24dB/octave Butterworth |
| Tone Controls |
Front Channels - Punch EQ
Treble: 0dB to +12dB @ 12kHz
Bass: 0dB to +18dB @ 45Hz
Rear Channels - Punch EQ
Treble: 0dB to +12dB @ 12kHz
Bass: 0dB to +18dB @ 45Hz
Function depends upon crossover setting (LP/AP/HP)
|
| Signal Input |
Front Channels: 1 RCA pair
Rear Channels: 1 RCA pair
|
| Signal Output |
1 RCA pair |
| Power Input Connector |
Block |
| Power Wire Gauge |
1/0 AWG |
| Speaker Output
Connector |
Block |
| Speaker Wire Gauge |
8 AWG to 18 AWG |
| Heat Sink Type |
Cast aluminum |
| Cooling |
Convection |
| Remote Controls |
Optional Remote PEQ
(overrides rear channel built-in Punch EQ) |
| Visual Indicators |
Power (Blue LED)
Thermal (Red LED)
Protect (Yellow LED)
Front Output -00dB to +2dB @ 11 steps (Blue LEDs)
Rear Output -00dB to +2dB @ 11 steps (Blue LEDs) |
| Circuit Topology Class |
Class A/B |
| Frequency Response |
20Hz to 20kHz +/- 1dB |
| Shipping Weight |
TBA Lbs.
(TBA Kg) |
| Dimensions (HxWxL) |
2.14 x 8.14 x 21.875 (in)
5.42 x 20.68 x 55.66 (cm) |
| Dimensional Diagram |
 |
Need a powerful amplifier to drive a 2-ohm stereo speaker system with a 4-ohm bridged/mono woofer load? This is the perfect amplifier for you, and with 1,000 watts divided between 4 channels, you will never run out of bass pumping power.
